What do the default yields represent, and can I override them?
derived
They are conservative planning values per feedstock, drawn from the shipped parameter packs with their provenance attached - which you can read in full on the components page. Override them with your own tested figures where you have them, because real Napier and crop-residue yields vary by a factor of two between sites.
- Source
- lib/catalogue/components.ts; Down To Earth on yield variability
- derived
- Reasoned from sourced facts or engineering fundamentals, not quoted from one.
- Level
- Practitioner — Operating numbers, ranges and failure modes.
Where this shows up while you build
This answer is attached to the controls it explains, so it appears beside them in the builder rather than only here.
Read next